The Fitout Pontoon
Advertise with Us Contact Us Glossary
Home » Product & Planning Guide » Safety & Security » Ventilation on Canal Boats & Narrowboats


Here we give guidelines, referencing the Boat Safety Scheme, on the provision of ventilation.

A subject not to be taken lightly as lives depend upon adequate provision. In all cases, you should satisfy yourself that your craft meets with current legislation and if you are unsure consult your local BSS examiner or surveyor.

Appliances on board that use LPG, coal, oil, wood or other carbon based fuels require an adequate supply of oxygen to burn efficiently. Inadequate ventilation will starve the burners of vital oxygen resulting in poor burning. Poor burning can produce highly toxic carbon monoxide. Carbon monoxide is a killer at worst and can cause severe brain damage at best.
Room sealed appliances take their combustion air supply from specific external flue ducting. However all other appliances, flued or not, will take their combustion air supply directly from the cabin space.
The formula used to calculate the fixed ventilation requirement is derived from BS 5482-3 Annex B (Code of practice for domestic butane and propane gas-burning installations — Part 3: Installations in boats, yachts and other vessels), but as extended by BS8511 Annex A (Code of practice for the installation of solid fuel heating and cooking appliances in small craft) to address solid fuel stoves and other appliances.(BSS revision Jan 2013).
The formula takes into account the number of people on board as well as the number and type of appliances installed. It uses the output rating of open flued  solid fuel appliances and the input rating for all other appliances, distinguishing between those that have flues & those that don't. This rating is kW, or kilowatts, and this can usually be found on the manufacturers plate on the appliance, in the operating instructions or from the internet. We have developed a handy audit sheet and calculator so you can check your own appliance/ventilation requirements.
Be honest with yourselves and list the maximum numbers of people who potentially will use your boat. It’s better to be cautious and safe when dealing with carbon monoxide.
BSS recommend fixed ventilation is split as equally as practicable between high level and low level outlets. Their examiners will not include vents that can be closed without the use of tools and on adjustable vents such as roof mushrooms, the vent will be measured in its most closed down position.
High level is ideally in the cabin roof and commonly takes the form of mushroom vents which often can be adjusted. Ensure yours have a screw stop installed so they cannot be fully closed.
Low level venting can be achieved by letting in cold air through louvre vents in doors, bulkheads or by ducting from a higher level. Cabin bilges should also be open to unrestricted ventilation to prevent the formation of mould from excessive moisture and to protect against the build up of gas in the unfortunate event of system leak.
The examiner will carefully examine any fixed ventilation for fly screens or louvres & carefully measure these potential restrictions so as not to render calculations inaccurate.

Complete the boxes below for ventilation calculation. For multiple appliance installations, click the 'Add Appliance' button & add information as required.

Enter the number of people for which compartment is designed:    

List Appliance Type below
E.G. Spinflo Hob or Morso
Input(kW) of Appliance or
output(kW) of Solid Fuel
Flue Type
Add Appliance

Note: This calculator is intended as a guide only. Please refer to your boat builder, BSS examiner or Marine surveyor when specifing and installing appliances on your individual craft.
Would you like a Quotation?
We're Always On Hand To Help Source You
The Right Products At The Right Prices"
Featured Pages

Featured Advertisers

Copyright: The Fit Out Pontoon Ltd 2012 /Terms and Conditions / Sitemap